ZebraPleco.com • The complete Hypancistrus zebra resource

Posted: **Wed May 30, 2007 7:11 pm**

Great work

Posted: **Wed May 30, 2007 7:48 pm**

Amaaai, looking good flip

Posted: **Wed May 30, 2007 7:51 pm**

Where did the heater go?

Posted: **Wed May 30, 2007 7:56 pm**

It's behind the filter inlet at the right side

Posted: **Sun Jun 03, 2007 6:52 pm**

I found a powerhead with a diffusor system so I replaced the internal filter with the powerhead. Will my zebs like this or is this a bit too much?

The power is adjustable...

Posted: **Sun Jun 03, 2007 7:20 pm**

1. Is the intake side of the powerhead safe for the zebs so they can't get trapped or sucked in?
2. Have you got it on a timer?
3. What's the capacity of the powerhead?

Posted: **Sun Jun 03, 2007 7:30 pm**

1 I think its safe, the intake is covered so they cant get sucked in.

2 I haven't got it on a timer, I think I can still feed my zebs on the left side. If not I will adjust the power at feeding time or put it on a timer.

3 the capacity was 2000 L/H but I made some changes because it was too strong.

Posted: **Sun Jun 03, 2007 7:37 pm**

Sounds OK to me then

Posted: **Sun Jun 03, 2007 8:29 pm**

If you leave it like that for about 3 weeks, then adjust it to a lower output, it might just trigger a spawn

They might think the flooding/rainy season is over

If you notice they are less active than usual it might be a good idea to adjust it a bit too.

Lots of oxygen there! Looks fine.

ZebraPleco.com • The complete Hypancistrus zebra resource

My set-up