tools:
petbox size M
a piece of filtermat 3cm fine
2 sucker with a head
multitool with a cutter
multitool with a drill
spongefilter for filtration
step 1. Connect the cutter and start to cut on side of the plastic box 2 cm from the edge
step 2. Clean the edges with a knife or your fingers for melted plastic ( can hurt the fries beacause it's sharp)
step 3. Connect the drill and cut 2 holes 4-5cm from the edges in both sides.
step 4. Make shure that the holes are smaller than the head of the suckers head ( if they arent they wont fit)
step 5. Put the 2 suckers in.
step 6. Now take a piece of filtermat and cut in so it cover the whole side (2cm wider than the cutting of the side of the plastic box)
step 7. Take the 3cm filtermat and cut i in half.
step 8. Cut now the smaller piece 1cm deep (its for the edges of the plastic box).
step 9. Clap yourself on the shoulder beacuse u know are ready