ZebraPleco.com • The complete Hypancistrus zebra resource

I always used a "vinkelslip" dont know the name in english but a handmachine for cutting slates.It was ok but only that.Sometimes it was hard to get it straight, then gugge from the forum told me about cuttermachine in a swedish store.So i bought it today.The slate cut was perfect and i was like cutting in butter .So i just wanna share som pics to u about my machine and the cutting and final results

looking good Edlund! How much did it cost?

where is the mess???

It's a swedish machine. They don't make a mess!

Looking good there, Edlund

I am also curious about the cost

I think "vinkelslip" is "angle grinder"?

Oh, my dad's got an angel-grinder and he's going make me a couple of caves (he doesn't know that yet )

The cost was 0 but if you buy it that will cost 500se kr.its around 50 euro.Im gonna take care my parents garden why they are away so they gave the machine!.Really nice i think

And of course you dont have to clean it beaucuse it swedish product.high quality from biltema

kingfisher wrote:Looking good there, Edlund

I am also curious about the cost

I think "vinkelslip" is "angle grinder"?

yes its a angelgrinder

I got the time to make one tonight it turned out good! but not perfect as yours edlund but close to!

Obviously we at Zebrapleco.com do not condone the use of Safety Glasses during the use of such machinery

Very nice pictorial description, cheers.

Rob

Edlund wrote:The cost was 0 but if you buy it that will cost 500se kr.its around 50 euro.Im gonna take care my parents garden why they are away so they gave the machine!.Really nice i think

And of course you dont have to clean it beaucuse it swedish product.high quality from biltema

Edlund, you now my English is bad
But what i understand. You are taking care of the garden and even in same time make some caves?
So Edlund you are more than Welcome to me!